IND-01
IndustrialNew tool installation
Power, disconnects and final connections for production equipment arriving on a plant floor. Set, landed, tested and turned over to the people who have to run it.
Tool installation
Building today. Powering tomorrow.
Soto Electrical Services works plants, commercial buildings and data centers across Phoenix, Tempe, Casa Grande, Eloy, Goodyear and Laveen. Tool installs, selective demolition, facility upgrades and the maintenance that keeps all of it running.
We come to you. There is no shop to visit, and the board is built around plant and commercial work, which means the crew is sized and equipped for the job you actually have.
Emergency services available 24/7. When a fault has already stopped production, call and you get a person, not an answering service.
Send the scope, the site and the window you need it done in. We price each project on its own drawings, so there is no rate card to work around.
About the company
Jesus Soto started the company in November 2024 with a narrow idea of what it should be good at: the electrical work that keeps industrial and commercial operations moving, done by a crew that shows up when it says it will.
That focus is why the service list reads the way it does. Selective demolition, tool hook-ups, plant maintenance, facility upgrades and data center power are jobs where the cost of a mistake is measured in downtime rather than inconvenience. They reward planning, clean documentation and a crew that knows what it is allowed to cut.
What we install and maintain
Ten electricians work out of Laveen and cover the I-10 corridor. Every job is quoted from its own drawings and its own site walk.
See every servicePlant floors, manufacturing facilities and the equipment that runs on them.
→
Scopes we take on
These are the scopes the crew is set up for. If yours sits next to one of them, send the drawings and we will tell you plainly whether it is ours.
Get a quoteIND-01
IndustrialPower, disconnects and final connections for production equipment arriving on a plant floor. Set, landed, tested and turned over to the people who have to run it.
Tool installationIND-02
IndustrialSwitchgear, panelboards and feeders replaced or added when a building has outgrown the power it was built with. Staged so production keeps running through it.
Facility upgradesIND-03
IndustrialScheduled inspection, testing and repair of the distribution that everything else depends on. Findings written down, not described over the phone and forgotten.
Industrial maintenanceCOM-01
CommercialUnderground through rough-in through trim on commercial builds and tenant work, coordinated against the general contractor schedule rather than our own.
New constructionDCX-01
Data centersOne-line development, main feeders, branch wiring and the maintenance that follows, in rooms where an unplanned outage is the only outcome nobody accepts.
Data center electricalDEM-01
DemolitionRemoving exactly the circuits, gear and conduit that are leaving while everything still in service stays energised and untouched.
Selective demolition
Where we work
The crew is based in Laveen and works the I-10 corridor, which is where most of the valley industrial and data center capacity actually sits. Sites east toward Tempe and south toward Casa Grande and Eloy are all inside the normal run.
Where to start
Each one explains how that work gets quoted, staged and executed, and what the crew brings onto your site.
All services
Industrial
Tool installs, plant maintenance and facility upgrades for Arizona plants.
Industrial work
Commercial
New construction, refurbishment and the removal work that comes with it.
Commercial work
Data centers
One-line, feeders, branch wiring and maintenance along the I-10 corridor.
Data center workLicensed, bonded and insured
Send the scope and the site. You will get a straight answer on whether it is work we take, and a written price if it is.